Garage Door Opener Repair

You might discover that your garage door opener has actually been providing you problems, so you need to repair it. You can fix it by changing a circuit board, a photo-eye sensor, the main drive gear, or the set-limit switches. You can likewise check if the safety and security sensing units are working effectively.

Replacing a motherboard

Changing a motherboard for your garage door opener needs a couple of actions and tools. Initially, you require to shut off the breaker and also detach any type of cables. Next off, open up the circuit card cover. This will certainly aid you to detect the trouble as well as determine if you need a brand-new board. Next, get rid of the old board and also its cable ports.

You can then continue to change the motherboard. The substitute procedure is simple and takes around 10 minutes. A new motherboard will certainly set you back about $80. To protect your new motherboard from power surges, you can acquire a rise protector.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensing unit can be a fairly simple task. First, remove the sensing unit from the door and also ensure it is located appropriately. If the sensor is angled at all, it may not be obtaining the right signal, which can be triggering the blinking lights. If you notice that the photo-eyes are out of alignment, you may need to have a specialist come and also take care of the trouble.

The photo-eye sensing unit includes 2 items that install on the outside of the door tracks and also toward the floor. The image eyes will certainly have a tiny LED light and also should be strong in color. If the light is blinking, its likely the photo-eye is defective and also will require to be replaced.

Changing a major drive gear

To replace a garage door opener major drive equipment, begin by removing the cap from the chain sheave. Next, remove the two screws holding the drive gear to the sprocket assembly. Currently, you can unfasten the 3 tension pins. Squeeze them from both sides and then eliminate them. Then, detach the three cables from the garage door opener electric motor. These wires ought to be white, red, as well as blue.

Once you have actually eliminated the old gear, mount a new one. Make sure to oil it well. Put the new equipment right into the shaft, seeing to it to align the placing openings. See to it the equipment as well as gear assembly are positioned appropriately to guarantee smooth procedure. Next off, use a hammer as well as a nail to drive a pin right into the new equipment.

Readjusting the set-limit switches

The first point you need to do if your garage door is not functioning properly is to examine the set-limit buttons. You might need to change them to make sure that the door shuts earlier or stops before it reaches the floor. You can examine this by looking at your garage doors manual or online.

To adjust the set-limit buttons, youll need a screwdriver or socket. Readjust the knob clockwise or counterclockwise till the door moves up and also quits, or lowers its distance. To look for proper travel distance, determine the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/